This new Single SPOOL THREAD HOLDER is simply a must for anyone using the larger thread spools or cones for sewing, embroidery, or for winding bobbins.  It comes with two thread caps to use on both small and large spools to insure a smooth feed.  The stand can be used upright or in the horizontal position. It works great for metallic and other slippery threads, but is spectacular for spools and cones of any sizes.  If you own a SideWinder Bobbin Winder, this is a must have item as it will make winding bobbins from large spools or cones a breeze!   Yes- this is an item you can use WITH the sidewinder to wind bobbins from the larger mini kings or cones of bobbin thread.  This is a brand new item and we are the first to offer it.

Universal Thread Holderis sew much better. It has Ultras smooth thread handling. Can be used in the horizontal or vertical position. The Universal Thread Holder. When used properly, it will quickly become your favorite external thread stand. Use it for sewing or for winding bobbins. Spools or cones of thread up to 76mm (3 inches) in diameter will fit on this thread stand. Now you can sew with all those threads that will not fit on your sewing machines spool pin.

Proper thread handling is very important to your sewing machine. Any obstruction to the thread flow from spool to needle can cause problems, such as broken needles or inconsistent stitching. These problems are inconvenient and can be reduced when using the Universal Thread Holder.

There are two spool caps and one cone adaptor included. These are used specifically for different types of spools. The idea is to keep the spool from turning while allowing the thread to spool off with no resistance, The small cap is intended for small diameter spools. Note that the spool is the plastic core that the thread is wrapped on.

The larger cap is for medium to large spools. The side placed against the spool should be larger than the spool itself. This way the thread spools off on the edge of the cap, NOT on the edge of the spool. When pushed all the way down onto the spool they prevent it from turning as well.

The cone adaptor is used for cone type threads where the opening is about 25mm (1 inch). It is a snug fit on the steel pin so as not to slip off when removing the cone. For most cone type threads the adaptor need only be installed flush with the end of the spool pin. Wiggling the adaptor while installing or removing makes the process easier. The cone can now be held in place allowing the thread to spool off to the exit hole. The two spool caps can be mounted on the spool pin (at the bottom of the cone) for storage.

After securing the spool or cone, the thread must pass through the exit hole opposite the spool pin. At this point the thread is free to go wherever you would like. The swing up & down guide wire is available to gain some height to clear a cluttered sewing table. When placed vertically with the guide wire extended up, it stands 15 inches tall, clearing the tops of most sewing machines. As with any external thread holder, care should be taken to keep the thread clear from obstructions or moving parts.